HOME    About this site    mypage    Japanese    library    university    Feedback

University of the Ryukyus Repository >
Faculty of Engineering >
Bulletin >
The Bulletin of Science and Engineering Division University of the Ryukyus >
No.5 (1972/03) >

 
Title :3次元壁面噴流による断熱壁面上の温度効果についての研究 第2報:2個の正方形噴口を持つ場合
Title alternative :An Experimental Investigation of Temperature Effectiveness of an Adiabatic Flat Plate Covered by a Three-Dimensional Wall Jet Flow. 2nd Report : Wall Jet Flow Issuing from Binary Square Nozzle
Authors :長田, 孝志
親川, 兼勇
Authors alternative :Nagata, Takashi
Oyakawa, Kenyu
Issue Date :Mar-1972
Abstract :In the previous report, Experimental results of the jet development and the temperature effectiveness on the adiabatic flat surface in the three-dimensional wall jet flow are discussed. This paper deals with a continuous experimental study in which the flow and the temperature fields on the adiabatic flat surface in the threedimensional, incompressible, turbulent wall jet flow issuing from two square nozzles are discussed. Maximum velocity decays and growthes of half-velocity widthes on both central lines of the nozzle and the flow, growth of equi-velocity lines, and distribution of the temperature effectiveness are reported with varying the central distance of the nozzles, the injection velocity and the temperature of the injection jet. The flow fields of such jets are found to be characterized by two distinct regions ; One shows two peaks flow and the other shows one peak flow which is observed at far downstream. The flow patterns as well as the temperature distribution differ at both regions. Transition points between these two situations are much depending on the central distance of the nozzles, but less on the initial velocity. Flow visualization, with using oil-film technique, has been tried to observe and grasp the induced flow situation (or entrainment of surrounding fluid) along the wall, and reasonable explanation for the velocity defects in the neighbourhood of the potential core regions could be obtained by its photographs.
Type Local :紀要論文
ISSN :0387-429X
Publisher :琉球大学理工学部
URI :http://hdl.handle.net/20.500.12000/24034
Citation :琉球大学理工学部紀要. 工学篇 = Bulletin of Science & Engineering Division, University of the Ryukyus. Engineering no.5 p.17 -28
Appears in Collections:No.5 (1972/03)

Files in This Item:

File Description SizeFormat
NO5P017.pdf6292KbAdobe PDFView/Open